May 21, 2024
The Microsoft 2010 C++ Redistributable must be installed before installing DavLink. If this is not done, a “bad license key” message will be displayed after entering […]
An Archive of the Andrew’s Advice feature.
May 21, 2024
If all the front panel LEDs are lit up and the Pause and Local are blinking, this could indicate a bricked unit. Verify with a manual […]
May 21, 2024
If unable to connect via the front port after a reboot or power cycle, try disconnecting and reconnecting the USB cable to reestablish the Comm Port […]
May 21, 2024
One way to correct this is with a manual factory reset: step 13 of the 5.56d firmware upgrade document. Click below to see more. https://dex.davicom.com/wp-content/uploads/2023/04/Davicom_Version_556d_Upgrade.pdf
May 21, 2024
A configuration can be lost after a reboot or power cycle if the RAM battery voltage is too low. A low voltage flag can be used. […]
May 21, 2024
You can easily download the desired workspace from a Davicom Cortex and set it as the default in DavLink. Click below to see more. https://dex.davicom.com/kb/how-retrieve-workspaces-from-a-cortex/
May 21, 2024
This is normal operation. The DavLink software is optimized for low bandwidth IP communications and loads a default workspace. Click below to see more. https://dex.davicom.com/kb/how-to-change-the-davlink-6-default-workspace/
May 21, 2024
When analog input 12 is used to monitor the RTC battery, it can then be configured to raise the alarm. Click below to see more. https://dex.davicom.com/kb/how-to-set-the-internal-jumpers-and-dip-switches-cortex-320/
May 21, 2024
If you want to monitor the RTC battery, analog input 12 is used. Click the link below to see more. https://dex.davicom.com/kb/how-to-set-the-internal-jumpers-and-dip-switches-cortex-320/
