AXON/NEURO Commands
The AXON/NEURO Command screen allows configuration of the various parameters to send a relay action command to a remote AXON-5R (or NEURO) device over an IP network. Note that the IP settings (UDP port and PSK) must have been pre-configured as shown in this article.
A Send Command test button is also available to validate operation during setup.
Cortex/DV200 Commands
This screen allows configuration of commands that can be sent to Davicom Cortex or DV-200 units.
The IP address of the remote unit must be entered, as well as which Command Flag in that unit is to be controlled. The Community is an “SNMP-like” password.
Configuring the Relay Outputs (AXON-5R only)
The screen below shows the settings for the Relays. Besides the descriptions, the only other settings possible for relays are their Mode (Any, Pulse Only or Latch) and the Pulse Width (in 0.1 sec increments with a 0.2 sec minimum). The maximum pulse width is 9999 seconds (=166.65 minutes, = 2.7 hours)
