Default IP address (192.168.1.210)
The AXON/NEURO’s factory default IP address is 192.168.1.210.
For the next steps, you will need to temporarily set your computer’s IP address within this range or create an Alias in your computer’s Network settings. For example, you can use 192.168.1.211.
Mandatory initial login credential change
The state of California has enacted regulation SB-327 that dictates that all IoT devices that are sold or offered in the state of California must adhere to specific regulations in regards to passwords configured on the device. All passwords are required to either be unique or prompt for a password change before the user has access to it.
Upon first log-in, AXON/NEURO units require that a Supervisor User enter their own password. Default, factory-set passwords are no longer allowed.
NOTE: This is also the point where you can select whether the AXON/NEURO will be configured as a Standalone unit for Web & SNMP or if it will be used as a MODBUS slave unit.
This mode can be changed later, from the Administration/General menu, without doing a factory reset.
After this initial step, the first Login process can take up to 30 seconds while the system configures its setup and web page views.
Network setup
Once you have set the username and passwords, you will be able to access the setup menu. From the Home Page, click on the hamburger menu at the upper left.
The following drop-down menu will appear.
Select IP Parameters and then the General Tab
General IP settings
Set the IP Address, Netmask, Gateway and DNS for your unit.
NOTE: The numbers entered in the fields below are only used as examples. Do not enter the numbers as you see them below, you must set the information according to your own device and network setup.
It is very important to set a gateway, otherwise, the unit may not communicate successfully with the outside network.
Save the IP settings.
