How to Configure Log and Status Report Information (Cortex series)

1. Go to the Logs menu.

2. Go to Log Transfers.

3. In the System Status tab, select the Log Transfer Type.

4. Select the Callout Device.

5. Set the Transfer Time. This is the time at which the System Status report will be sent.

6. Set how often the transfer will occur.  

7. Set the Number of attempts.

8. Set the Delay between attempts in minutes.

9. Enter the phone number, email, etc. to which the System Status report will be sent. The format must correspond to the Transfer Type you set earlier.

10. Save the configuration. 

11. Go to the System Log tab.

12. Select the Log Transfer Type.

13. Select the Callout Device.

14. Set the Transfer Time. 

15. Set how often the transfer will occur. 

16. Set the Number of attempts.

17. Set the Delay between attempts in minutes.

18. Set the memory percentage usage at which you want the System Log to be sent.

19. Enter the phone number, email, etc. to which the System Log report will be sent. The format must correspond to the Transfer Type you set earlier.

20. Save the configuration.

21. Exit the configuration screen.

Was this article helpful?
Dislike 0
Views: 16

Leave a Reply