September 15, 2025
Directors, Supervisors, Administrators, and Operators can take control using the “Take control” command is in the Administration window under the System menu.
FAQ specific to the DV-200, 2nd generation of Davicom RTUs
September 9, 2025
Yes, CORTEXes, NEUROs, and DV-200s can use SNMP GETs to retrieve and display info.
September 9, 2025
Yes. CORTEXes, NEUROs, and DV-200s can use SNMP GET/SET or UUC commands to control another unit.
May 20, 2025
Only users with Supervisor or Director level access can take control of a unit remotely and cancel “Local” mode. This is a safety feature to ensure […]
May 12, 2025
A Davicom unit can be in “Local” mode because someone pressed the “Local” button on the unit at the site or because a Supervisor put the […]
May 5, 2025
“Pause” mode may be remotely canceled by a user with Administrator or higher access level. This is a safety feature to ensure that local technicians can […]
April 28, 2025
A Davicom unit would seem stuck in “Pause” mode when you connect because: 1- Someone has pressed the “Pause” button on the unit at the site […]
April 22, 2025
Once an alarm proceeds past the alarm popup stage, it follows the programmed sequence unless acknowledged by an authorized user through the appropriate interface.
April 14, 2025
If the system is unattended or if a view-only user is connected, the alarm bypasses the alarm popup and proceeds according to the alarm configuration and […]
